Guide :Camping, Backpacking & Hiking : Porta Potti

Toilet won't flush. New pump fitted fuses ok.

Posted by fredparkin on Jul 30, 2009

Research, Knowledge and Information :

how to mend it .com - Thetford cassette toilet won't flush ...

Thetford cassette toilet won't flush? ... Re fit flush tube to new pump and test using a bucket of ... in cable if current drops or not showing and fuse is ok.
Read More At :

Toilet Won't Flush - Avondale Caravans - Caravan Talk

Toilet Won't Flush - posted in ... You should have a pump which is usually blue colour ,a relay which you can hear clicking ,if ... Even though the fuse looked ok it ...
Read More At :

Thetford Cassette Toilet Not Flushing - YouTube

Jul 07, 2014 · Toilet just stopped flushing. Tried swapping fuses and ... Toilet just stopped flushing. ... Remove "Black bits" from a caravan toilet flush tank ...

thetford cassette toilet C2. Fuse is OK but pump does not work

thetford cassette toilet C2. Fuse is OK but pump does not work to flush toilet. ... The switch doesn't work. Check the switch by pushing the flush knob.
Read More At :

Thetford Toilet Won't Flush - Caravan Toilet - Caravan Talk

Thetford Toilet Won't Flush ... I have since discovered that Thetford have fitted a drain cock to the flush tank to prevent the ... I have a new pump on order now ...
Read More At :

Thetford C250 won't flush | MotorhomeFun | The Motorhome ...

Thetford C250 won't flush. ... Ordered new push switch and reed switch fitted both still ... Appreciate you've checked the pump, ok. But - have you checked the fuse ?
Read More At :

Thetford C262 Toilet Flush pump Caravan ...

Just been away for the weekend and found that the flush pump doesn't work. The fuse is ... probably won't have time ... Caravan Repairs, Servicing and Maintenance
Read More At :

how to mend it .com - Thetford C200 CWE toilet will not flush ...

... and I now find that the toilet will not flush. The 3a fuse is OK, ... The pump is held in place by a push fit bracket and the ... The tank is empty and won't ...
Read More At :

Suggested Questions And Answer :

Toilet won't flush. New pump fitted fuses ok.

Thetford Model Cass C2 L TC WHI - Toilet won't flush. There is power to the switch and flasher. Any ideas?
Read More At : Porta Potti...

Casset toilet will not pump water for flush

Open door, remove toilet cassette unit, look in under flush water tank, observe a short metal blade that actuates a safety switch. This is between two plastic guides. Now look just outside the right hand guide. There you will find the fuse which is a standard blade type. Just pull it down to remove from holder. You will probably find it rated at 3 amp. If it is blown you will probably have to replace pump. Looks difficult but is actually dead easy. Instructions come with replacement Thetford pump. Only problem you may have is a perished sealing ring on the paper holder cup which is no longer available as a spare. Just use a good quality outdoor type sealant as a replacement. Be sure to recover any bits of broken ring from the flush water tank as these can be drawn into your replacement pump and cause it to sieze. At minimum this will cause you to say bother! Happy repairing.
Read More At : Porta Potti...

Manual for 1992 Fiamma porta potti

Sorry, don't mean to be pedantic but Fiamma is just a potti not a Thetford Porta Potti. (TM)I only have experience with Thetford.
Read More At : Porta Potti...

Toilet not flushing pump not working - Thetford Porta Potti

Had the same problem a few years ago, the cause was a seized pump blowing the micro switch fuse. To repair turn off 12v and check/replace the circuit fuse. If that's OK, remove toilet roll holder (it pulls out) and release the pump from its well, a crosshead screw holds it in place (don't disconnect the wires) twist the impeller to ensure its free ... switch on 12v and press flush... refit if it now works....if not check/replace the micro switch fuse which is accessible after removing the cassette. If it still doesn't work check that there is power to the micro switch fuse holder, when you press the flush (use a bulb or meter). If there's power then the pump may need replacing, check it when you've disconnected it from the micro switch and before removing it from the tank. New pump is about thirty pounds and like the fuse is a pain to fit.
Read More At : Porta Potti...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || || Terms of Use || Contact || Privacy Policy
Load time: 0.0388 seconds