Guide :Camping, Backpacking & Hiking : RX3019 Rechargeable Flashlight 110V AC Converter

Repaced bulb and battery light will not come. Switch replaced in 2004

Posted by w_d_dailey on Apr 06, 2010

Research, Knowledge and Information :


How to Fix Tail Light Problems in Under 20 Minutes


How to Fix Tail and ... To test for this condition expose the tail light bulb in question. Next, switch the tail lights on ... the switch should be replaced.
Read More At : www.2carpros.com...

What Does the Battery Light Mean on Your Dashboard?


Is your battery light on? ... go ahead and check your battery connections. The light can come on even if your alternator belt is intact and your alternator is ...
Read More At : www.thoughtco.com...

ABS Light Due to Poor Electrical Ground Under the Battery ...


Chevrolet Silverado 2500 HD ABS Light Due to Poor Electrical Ground Under the ... Light Due to Poor Electrical Ground Under the Battery ... so replaced it and still ...
Read More At : repairpal.com...

2001 Honda Civic: light bulb..turn signal lights come..headlights


I replaced the small parking light bulb on my 2001 Honda ... The bulb I repaced was from the Honda ... What make the battery light come on when coming to a stop? 5 ...
Read More At : www.justanswer.com...

3 Ways to Fix a Stuck Brake Light - wikiHow


Sep 02, 2016 · wiki How to Fix a Stuck Brake Light. ... I recently got my brake light switch replaced. ... "Helped a friend not to have a dead battery the next day from ...
Read More At : www.wikihow.com...

Chevrolet Car Repair Questions and Answers Lists


Read through our Chevy car and truck auto repair questions and answers. ... I have 2004 Chev Venture was having a battery issue with ... light never has/did come ...
Read More At : www.greatautohelp.com...

Infiniti G35 Electrical Issues — Car Forums at Edmunds.com


I've been told the battery was too old and not holding a charge. Replaced the battery ... release switch. Replaced ... as the trunk light. I replaced the ...
Read More At : forums.edmunds.com...

Suggested Questions And Answer :


Repaced bulb and battery light will not come. Switch replaced in 2004


The switch probably went bad again, contact Maglite at www.maglite.com and they will replace it at no charge.
Read More At : RX3019 Rechargeable Flashlight 110V AC Converter...

Need to replace switch in my flashlight - MagLite RX3019 Rechargeable Flashlight 110V AC Converter


Jason, on April 24 I sent you the solution as to how to replace the SWITCH in your Maglite. :)
Read More At : RX3019 Rechargeable Flashlight 110V AC Converter...

How to replace witch assembly in rechargeable Maglite?


1st, remove the battery via the **** end of the barrel. 2nd, carefully remove the little RUBBER CUP that covers the depression off/on switch. Gently maneuver it out by lifting the edge of it then pulling it out. Do not cut or puncture it. This little rubber cup keeps water and dirt out of the switch. 3rd, Remove the HEAD (light assembly) off where the charging rings are, just behind the switch. Hold the barrel with one hand and with the other twist the head until it begins to unscrew from the barrel and until it is free. Upon completion of this step, set the barrel aside. If you have a digital camera you can photograph each step of this so that when you reassemble, you can simply refer to the photos for reverse order assembly. 4th, Unscrew the LENS CAP and set it aside. At first it may seem as if it is not unscrewing but keep going as it will come off. Upon completion, set the lens cap aside. 5th, Hold the BULB with a tissue and pull straight out with out twisting. Do not hold these types of bulbs with your bare hands as the moisture and oils of your skin can damage the bulb when the switch is turned on. Upon completion secure the bulb and set it aside. 6th, You will now be left holding the BEAM ADJUSTMENT HEAD which also contains the OFF/ON SWITCH. 7th, Firmly hold the ADJUSTMENT HEAD (the large portion) in one hand, then place the small end in the palm of your other hand and push the small portion through and out of the large portion. Set the head aside. You will now be holding the short barrel which contains the bulb holder and the OFF/ON SWITCH. 8th, Now look at the OFF/ON SWITCH. You will see a white plastic cylinder looking up at you. When you push it down you will hear and feel it 'click as it is engaged in the 'on' position. This and the assembly it is contained with-in must now be removed from the short barrel containing it. *CAUTION* When you finally ( In step #9 below) remove the SWITCH from the short barrel, the assembly containing the switch itself will want to 'spring' apart into two halves because it is under slight pressure due to the spring which puts tention on the OFF/ON button. Hold it firmly until you have it completly removed from the short barrel. Pay attention as you do this so that you can remember how to put it back together at reassembly time. 9th, Using a small common tip screw driver, depress the WHITE plastic OFF/ON button as far down as it will go. While you are holding it down with the screwdirver use the thumb of your other hand and push against the BULB HOLDER, this will cause the SWITCH assembly to move forward about 1/4inch and to the point where you can release pressure on the switch with the screwdriver. At this point DO NOT continue pushing. 10th, look down into the barrel where the white plastic switch is that you had depressed in step # 9. You will see a BLACK plastic housing which holds the WHITE OFF/ON SWITCH. Using your small blade screwdriver, slide it behind the BLACK plastic housing and gently apply a prying pressure which will force that housing containing the SWITCH assembly, to move forward and exit the short barrel containing all of this. REMEMBER! It is at THIS point that the two-part housing holding the switch assembly will want to 'spring' apart. Pay attention and go slowly. When you reassemble this part of the flashlight, know that in order for the switch assembly to go back into the short barrel the WHITE PLASTIC OFF/ON button has to be DEPRESSED, do it with the screwdriver, enough to clear the interior side of the barrel. Depress it and gently push the assembly back into the barrel until it is back where it began. Be sure to line up the male notch on the exterior of the switch housing with the female grove of the interior of the small barrel. If you have the notch lined up and the switch button depressed all the way it will slip right into place with a happy clicking sound. Upon completion of that step, reassemble the rest of the components in reverse order. There you have it. Good luck. :)
Read More At : RX3019 Rechargeable Flashlight 110V AC Converter...

How do i change the bulb - MagLite RX3019 Rechargeable Flashlight 110V AC Converter


Unscrew the bottom portion, where the batteries go. Then unsrew the top where you can adjust the beam width until it comes off. Very carefully pull the bulb out and replace the old bulb with the new. The Reassemble is the reverse of the procedure.
Read More At : RX3019 Rechargeable Flashlight 110V AC Converter...

Change bulb light will not turn on


Try getting a new battery, and see if that works.
Read More At : RX3019 Rechargeable Flashlight 110V AC Converter...

Rechargable Stinger new bulb is dim orange


Could possibly be a bad switch, I would also get that battery tested out also. If you still have a receipt it should be covered under warranty. If not try sending it in anyway. Limited lifetime warranty does not include bulb, or batteries but, anything else on that Stinger should have a lifetime warranty. Of course that excludes abuse. Check out the website www.streamlight.com and go to FAQ for a nearest Authorized Service Center or send it directly to Streamlight. Address also listed on the website. Hope that helps ;)
Read More At : Streamlight XT Rechargeable Flashlight with Fast DC......

Not charging? - MagLite RX3019 Rechargeable Flashlight 110V AC Converter


Start out by checking the power transformer with a volt meter. It should read 13.8 volts. If you do not have volt meter, after the transformer has been plugged in for a few minutes, it should feel warm. Another possibility, which is more likely the problem, is that a battery or battery unit has gone bad and needs replacing.Good Luck!
Read More At : RX3019 Rechargeable Flashlight 110V AC Converter...

Can't open maglite up - MagLite RX3019 Rechargeable Flashlight 110V AC Converter


Need to replace batteries. Try to unscrew the bottom with the success. What am I doing wrong?
Read More At : RX3019 Rechargeable Flashlight 110V AC Converter...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.backpackingtips.net || Terms of Use || Contact || Privacy Policy
Load time: 0.0308 seconds