Guide :Camping, Backpacking & Hiking : 2M Pwr Rch Spotlight

I simply need to know what the 3 colored LEDs on the handle represent. There is a red one, an orange(yellow) one, and a green one. I lost the manual and need to know when the battery is fully charged. It seems the green one comes on only after it has been plugged into the charger for a while, but then what? How many hours do I leave it on the charger to get the battery fully charged but not over charged? By the way, if you are looking for the DMU 12-3 battery (12 volt 3 AH) I got one from BATTERYSPEC.COM...$16.50 plus $10 shipping.

Posted by wbs045 on May 04, 2017

Research, Knowledge and Information :



We did not find results for: i simply need to know what the 3 colored leds on the handle represent there is a red one an orange yellow one and a green one i lost the manual and need to know when the battery is fully charged it seems the green one comes on only after it has been plugged into the charger for a while but then what how many hours do i leave it on the charger to get the battery fully charged but not over charged by the way if you are looking for the dmu 12 3 battery 12 volt 3 ah i got one from batteryspec com 16 50 plus 10 shipping.

Suggested Questions And Answer :


I simply need to know what the 3 colored LEDs on the handle represent. There is a red one, an orange(yellow) one, and a green one. I lost the manual and need to know when the battery is fully charged. It seems the green one comes on only after it has been plugged into the charger for a while, but then what? How many hours do I leave it on the charger to get the battery fully charged but not over charged? By the way, if you are looking for the DMU 12-3 battery (12 volt 3 AH) I got one from BATTERYSPEC.COM...$16.50 plus $10 shipping.


Red, Yellow, Green are the battery level indicators, Red being the lowest like a fuel gauge. If the green comes on right away after plugging in the charger then it must not indicate the charge cycle. If its a 3Ah battery whats the charger output amperage? Then you could just do the math to figure out how long it would take to charge that battery to full with the output. Otherwise it shouldn't hurt it to leave it plugged in overnight or at least a few hours to charge it.
Read More At : 2M Pwr Rch Spotlight...

Recharging - indicator lights when complete


When the green light stays on that means the battery is fully charged. The correct charger for that light is a Class 2 Transformer Model: KA12D120030042U It has a output of 12VDC at 300 mA
Read More At : 2M Pwr Rch Spotlight...

I have brand new just fitted MK Gel batteries and a known working charger. When the charger is plugged in and charging a orange light should come on or green when fully charged. At the moment only the red power light comes on and the charging indicator light does not. It is a Pride Celebrity 4 wheel scooter. I have checked the voltage through to the controller box. Lights and controls working fine. Kind Regards David Hornby


Hi, Could be controller or maybe wiring is bad. If the green light doesn't come on then this would probably be the circuit breaker has popped or possibly a fuse blown somewhere. There may be a fuse on each of the battery harness leads, so they could be worth a check. May also be a bad connection somewhere or a broken wire. Also worth checking the key switch in case this is not working. If the green LED on the console IS on, is it flashing and if so, how many times. This is a built in diagnostic system and will tell you what is wrong with the scooter if you have the owner's manual to refer to.
Read More At : Camping, Backpacking & Hiking...

Makita ML 140 torch. Old battery would not hold a charge as it was very old. Torch works well with a new Makita PA14 battery. But the handle gets quite hot and I need to dismantle it to find the problem. One would not expect heat from the handle but rather from the head. I have undone the screws but the swivel part also has to be removed for access. What is correct procedure? I am radio technician Thanks, Dave B.


Remove the lens, and bulb holder. look down into the cavity, and you will be able to see the spring loaded pivots. Find sonething narrow to push them in with, so that you can remove the head. here is my fix (with photos) for the 18v version
Read More At : 12V Flashlight ML120...

My flashlight just stopped working. when placed on charger, the green charged light appears. How do I know if its a battery or bulb problem?


It's telling you the battery is fully charged so suspect that either the battery is dead or the bulb is burnt out. Get a test meter and test for voltage at the battery. If yes, then the bulb is burnt. If no voltage then obviously the battery is bad
Read More At : T4 Flashlight...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.backpackingtips.net || Terms of Use || Contact || Privacy Policy
Load time: 0.0284 seconds