Guide :Camping, Backpacking & Hiking : Night Ops Xiphos Nt Weapon Mounted Light, Black

When i depress the switch from the right it does not turn on, however pushing the switch forward or from the left side works but not from the right.

Posted by greyspyder98 on Mar 09, 2011

Research, Knowledge and Information :

How To Diagnose Brake Light Problems - AGCO ... - AGCO Automotive

When the lower lights do not come on and only the third-brake light works, the brake-light switch ... brake light does not flash with turn ... side brake light ...
Read More At :

Top 10 Scooter Problems & How to Solve Them! - Ooty's Scooters

Top 10 Scooter Problems & How to Solve ... (turn towards the right) ... Try putting the scooter on its side stand and push the scooter to its left side taking ...
Read More At :

Why Won't My Car Start? » News

Are you wondering "why won't my car start?" ... If the switch isn’t in the right position then the car just ... Occasionally it will not start. When I turn the ...
Read More At :

My car won't start, what should I do? |

My car won't start, what should I do? ... You sit behind the wheel and insert the ignition key into the switch. You then turn ... The negative side may or may not ...
Read More At :

Operating - John Deere

· To make a tighter right turn, depress right ... system by pushing in key switch until ... will lock right and left side rear axles together and cause ...
Read More At :

Gas Fireplace Repair: Do-It-Yourself Troubleshooting - Advice

Gas Fireplace Repair: Do-It-Yourself Troubleshooting. ... works, usually not. Flip the switch 50 ... when i turn the switch on, however within 20-30 minutes ...
Read More At :

Engine won't start ...clutch safety switch involved /manual ...

Engine won't start ...clutch safety switch involved ... happened to not turn over. i was happy i ... a nut and screw to depress the switch. I Crunk right ...
Read More At :

Chevrolet Malibu Questions - My ignition key will not turn to ...

My ignition key will not turn to ... or the ignition switch. If none of this works, ... pick along side of the key and started pushing up on the tumbler pins ...
Read More At :

How to Check Your Golf Cart for a Bad Solenoid | AxleAddict

How to Check Your Golf Cart for a Bad Solenoid. ... everything works normally. does this seem like a throttle ... will not go forward. If switch to ...
Read More At :

Suggested Questions And Answer :

Wiring spotlights to my snowplow/salter trucks

The single wire is the "hot" wire. The return is through the metal body of the spotlight. Run the single wire through the switch. Make sure that when mounting the light. you scrape off the paint to make sure metal is touching metal.
Read More At : Camping, Backpacking & Hiking...

I bought a vector 20 million power series sport/spot light and based my purchase on reviewsand company reputation. After receiving the light in the mail I followed the instructions charging it for the proper length of time then tried the light at night in a wooded area near my home. First impressions were anything but favorable, the light was poorly designed ergonomicallythe on-off switches were positioned to put it bluntly in a very stupid place making it awkward to turn off and on. I was ok with the lights size and weight it was just the way it was designed that made its size and weight a detriment to ease of use. Next after a several day full and complete charge I put the light in the trunk of my car to be ready for use on a weekend camping trip. When we arrived at the campsite and began setting up I got the vector out with high expectation of it lighting up my area so I could set up my tent so I set it up turned it on and at first thought wow this is great adjusted the stand started setting up camp when the brand new VECTOR 20 million candle power light slowly started to dim out all to my chagrin of course. within minutes it was dead as a doornail. Almost a HUNDRED dollars for a flashlight and my old trusty 1 million candle power DORCEY spotlight purchased from Harbor Freight that fortunately was in the trunk of my car came to the rescue.A cheap 10 dollar spotlight not only was brighter but it lasted the entire time it took to set up camp. After the weekend was over and I was back at home I emailed the vector company and to be honest was treated with a cross between sarcasism and indifference when I expressed my concerns. I was more than a little surprised and caught completely off guard so much so I allowed myself to be dismissed when I asked if I could trade in y brand new spotlight on one of equal or the one I was interested in trading on was a fair bit more expensive. My less than polite or helpful customer service represenative told me that they do not do that and in so much words he made it clear that I was stuck with the one I have and that it is clearly written in the ad that it is a large floodlight,. I gave up figured I had been stuck with the floodlight and swallowed my pride after writing a less than favorable review on the floodlight. I just had to write again I just took the light out to look at a car I had trouble with today turned it on and thought hey this is working ok but within 15 minutes the light dimmed very quickly till it was stone dead and I could not see anything. So out of sheer frustration I am writing this letter to express my feelings once more. Again I broke out my 10 dollar dorcey floodlight that had been hanging on a hook not plugged in and charging just hanging took it outside and it not only lit up my car but lasted the entire time and was still going strong when I finished brought it in hung it up and put the charger on it. So after this long winded explanation about one of your products it comes down to "I WOULD NEVER AGAIN BUY ANY VECTOR PRODUCTS NOR RECOMMEND THEM TO ANYONE!" I am stuck with this lemon I am trying to decide what the best job could be for this floodlight and all I could think of is that it would work well as a corner weight on the tarpaulin that I have covering my car. Sincerely, James R. Clement. A dissatisfied customer .

This light has'nt really like others much that can go wrong. I'm sorry to hear you had so many problems. I have this light and recieved it second hand, without an owners manual. I went to which redirected me to Black & Deckers web site. I there downloaded an owners manual. If I would'nt have done that I may have also posted many of the questions reguarding this light. There are many inportant things to know before use and continued use. The bulb and battery are replacable. Hope this helps! Matthew
Read More At : 20 Million Power Series Spotlight...

How 2 switch modes on the Black & Decker light BFMAKB2? when in constant light dies in 30 sec.but when in blinking mode it keeps the light broken am I a I D I O T whats wrong?

When in the blinking mode it uses a significantly smaller amount of current. It's possible the switch itself is faulty or the battery isn't charging.
Read More At : Camping, Backpacking & Hiking...

Maglite LED. Light switch is intermittent. Have had the same issue with my 8 month old 2AA LED Maglite, don't have receipt and have tried finding a solution to get it fixed again. Lost my temper with it on a job on Friday night and smacked it into a flight case several times (was doing some urgent troubleshooting midway through the show) which seemed to fix it temporarily, however started playing up again Saturday night. The next solution was ebay and getting a new one, and this time I will be keeping the receipt and paperwork. I hope we have just been unlucky as there doesn't seem to be many people with the same issue.

Hi,Unfortunately not, I've seen more and more of these coming back to the shop here with faults. Mostly they seem to be connection problems like yours. Pity, MAG are excellent and have really tarnished their reputation with this LED gimmick. A lot of the customers who return their LED's to us take a traditional MAG as a replacement..
Read More At : Camping, Backpacking & Hiking...

The plastic part of the bulb holder broke. I got it back together but the lamp is now off-center and doesn't focus right. Obviously I need a part or parts. Can this light be converted to an LED, which would be more durable? The light has been used very little. I discovered the problem because it worked sometimes, and sometimes not.

Yes you can just replace the bulb with a LED bulb you can buy LED bulb at the lighting stores . you must consider that LED bulb is less brighter than an ordinary bulb for on here to where you can buy your replacement LEDbulb..
Read More At : Gerber RX1050 Xenon Flashlight Black 22 80115...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || || Terms of Use || Contact || Privacy Policy
Load time: 0.0409 seconds