Guide :Camping, Backpacking & Hiking : TK11 R2

Model TK11: light wont stay on when tailcap pushed.

Posted by Anonymous on Mar 26, 2011

Research, Knowledge and Information :


Maglite Torch Problems Streamlight Microstream Flashlight 350 ...


if light and fast surefire rail mount flashlight best streamlight; ... size: its compact design and balanced fenix tk11; the tactical tail switch offers turbo, ...
Read More At : www.downrightflashlightsection.tech...

Star Wars Yoda Lightsaber Led Flashlight Surefire Led ...


8 inches item zap light for her led flashlightstun device fenix flashlights; most of the eveready led flashlight combo maglite battery stuck repair ...
Read More At : www.downrightflashlightsection.tech...

Suggested Questions And Answer :


Why wont my black and decker ultra bright spotlight stay on for more then 10 minutes ?


The batteries are probably no good or your charger is bad. But I say the batteries themselves are bad. All batteries will only last so long. And it also depends how often they are keep charged and discharged. Basically all batteries require some kind of maintenance (recharging / discharging).
Read More At : SPOT...

I need an instruction manual for the vector sport spot 3,000,00


Sorry Nancy, sounds as if you have a bad switch.
Read More At : Vector...

The switch on our almost new Life Gear Glow 300 hour LED spot light is not working. We replaced the batteries as we assumed that was the problem. When the switch is depressed the light flashes briefly


Sounds like the switch is intermittently contacting an needs cleaned , tightened ,or replaced try some wd 40 in it .it wont hurt the electronics or take the switch apart an clean
Read More At : Life Gear Flashlights LED 300 Hr Glow Spot Red Model: LG114...

My new flashlight wont stay on


Flashlights of this type are notorious for poor design. I had one where the contact spring at the top broke its connection. Others break the ground wire when the top is unscrewed. Another design flaw is trying to solder a ground connection to the anodized aluminum case - doesn't work. I am replacing the broken ground wires with longer, more flexible ones but that's not a permanent solution. Some LED board case grounds have been repaired by scraping the solder-to-case joint although in one case I had to replace the joint by wedging in a piece of bare copper wire. Hope these tips help.
Read More At : Energizer...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.backpackingtips.net || Terms of Use || Contact || Privacy Policy
Load time: 0.0319 seconds