Guide :Camping, Backpacking & Hiking : Original LED Book Light

Lightwedge-changed the batteries. It still does not work. Is there a way to open to determine if the switch is bad, or bulbs?

Posted by mpi53 on May 29, 2011

Research, Knowledge and Information :


How to Repair an Electrical Wall Switch - The Spruce


This tutorial describes how to troubleshoot and repair a wall switch ... a four way switch may be ... Light Fixture or Wired Device Does Not Work Are you ...
Read More At : www.thespruce.com...

Garage Door Opener Troubleshooting Tips - Advice


I’ve changed batteries, ... open. The light on the wall switch does not ... unplugging it to see if it would reset.but light still does not work… ...
Read More At : www.realestate.com...

Why won't my A/C turn on after I replaced the thermostat ...


Why won't my A/C turn on after I replaced the thermostat batteries? ... bottom of the kill switch or float. There is a yellow wire ... C still did not work, ...
Read More At : diy.stackexchange.com...

5 Ways to Change a Watch Battery - wikiHow


Jul 08, 2016 · How to Change a Watch Battery. ... There should be small screws on the backside of your watch. ... If it still doesn't work, ...
Read More At : www.wikihow.com...

Troubleshooting A Home Furnace Thermostat - PREFERRED HOME REPAIR


The back display light for the digital thermostat does not ... open connectio n; Dead batteries if ... can work on a millivolt thermostat. To determine if a ...
Read More At : preferredhomerepair.com...

SOLVED: Replaced battery but won't charge - iPhone 4S


Ask you seller to change it becoz these batteries will not work. this is very cheap battery it ... Replaced battery but won't ... Does anybody know if there is ...
Read More At : www.ifixit.com...

How to Change the Batteries in Your Smoke Detector: 15 Steps


How to Change the Batteries in Your Smoke ... If this battery does not work, ... How do I replace the cover of the smoke detector after I have changed the batteries?
Read More At : www.wikihow.com...

Everyday Home Cordless Ceiling-Wall Light With Remote Control ...


Everyday Home Cordless Ceiling-Wall Light With Remote Control Light Switch ... a couple of weeks then would not work at all changed batteries still does not work.

How to Fix a Garage Door Opener Remote That Has Stopped ...


How to Fix a Garage Door Opener Remote That Has ... that triggers a switch, promting an electric motor to open or ... but still does not work, there are ...
Read More At : homeguides.sfgate.com...

Suggested Questions And Answer :


What does 500 mcd mean in an led light - Lightwedge Original LED Book Light


Milli-candela (mcd) or Megacandela (Mcd), measurement units of brightness or light intensity
Read More At : Original LED Book Light...

I have a Cyclops 2 cell (2xCR123) flashlight that looks like the current CYC-XCF, but has no clip on the side. I bought two CR123-size cells that are rechargeable, but did not notice they are 3.7v each when fully charged. I put the cells in the flashlight right out of the package and they were GREAT--the light was as bright as I have ever seen it. I then recharged the cells, and when the switch was pressed on, the bulb went POOF! Obviously, a bulb designed for 6v was not up to handling 7.4v! In fact, I found one web site which described the bulb as "Ultra Bright 80 Lumens Xenon Bulb (T1-1/2 Xenon 4.8V)," for the new light with the side clip. 4.8v bulb for 6v?? Can you give me a part number for, a bulb which can handle two 3.7v cells? Since the original bulb might be rated at 4.8v, theone I need might be rated at 6v (over-driven by the same percentage). Thank you, Joe Hathaway


The CR123 is a 6-volt cell.
Read More At : ® XRF Xenon Rechargeable Flashlight...

Streamlight stinger LED 75711 will not turn all the way off. a very dim light stays on constantly


I think you are correct. Sounds like the switch.
Read More At : Stinger LED Rechargeable Flashlight-75711SL...

I have aCOAST flashlight 3 LEDs, Silver in colorand 3 LR1 batteries. Light is 5.5" long. Bad switch. Can it be repaired.


Yes.  Switches are cheap.  Go to Radio Shack and they will hook you up with the switch, some solder, and a solder tip.
Read More At : Coast LED Lenser LL7555 V8 Standard Torch bright LED......

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.backpackingtips.net || Terms of Use || Contact || Privacy Policy
Load time: 0.0441 seconds