Guide :Camping, Backpacking & Hiking : Benelli M4 Shotgun Picatinny Rail System M80 for SureFire...

How do you remove the rear sight on a Benelli M4 Shotgun - I am replacing the factory sights and need to remove the originals to replace them.

Posted by fiftycal on Aug 18, 2011

Research, Knowledge and Information :


Reviews & Ratings for Meprolight Tru-Dot Ghost Ring Night ...


I purchased a set of the Benelli M4 Ghost Ring Sights ... I took them off and reinstalled the originals. ... Tru-Dot Ghost Ring Night Sight for Benelli Shotguns ...
Read More At : www.opticsplanet.com...

M4 rear sight - Benelli USA Forums


I have ordered the Meprolight sights for my M4. The problem is I can't find any info or instruction to remove the rear sight. I'm sure it is something simple needing ...
Read More At : forum.benelliusa.com...

Benelli M4 owners. Anyone thought about REMOVING/REPLACING ...


You could get something like a fibre optic front sight post, then remove the rear ... remove a nut and replace the sight. ... M4 sights, but if I was to do ...
Read More At : www.ar15.com...

Help - Benelli M4 stock removal (w/screw inside) - Calguns.net


Jun 17, 2013 · ... Benelli M4 stock removal (w/screw inside) Shotgun ... I need some help trying to unscrew my Benelli m4 factory ... All you need to do once the ...
Read More At : www.calguns.net...

Benelli M4 -- Recoil Extension Removal - AR15.COM


... Benelli M4 -- Recoil ... 1:10:22 AM EDT I figured some of you Benelli M4 owners would find ... point to the middle of the rear sight ...
Read More At : www.ar15.com...

Gun Review: Linberta SA01LSTAC20 Shotgun - The Truth About Guns


Gun Review: Linberta SA01LSTAC20 Shotgun. Nick ... a poor man’s Benelli M4. I can’t fault them for that — there ... top rail and rear aperture sight where each ...
Read More At : www.thetruthaboutguns.com...

Ask Foghorn: How and Why to Co-Witness your Sights - The ...


... zero them and then ignore them until you need them. ... By using the rear sight you can make sure your head is ... How and Why to Co-Witness your Sights.
Read More At : www.thetruthaboutguns.com...

The Easy Way To Make Iron Sights Easier To See


The Easy Way To Make Iron Sights Easier To See ... You first remove any gun oil, ... If you want dots on your rear sight blade, you can add them quickly and ...
Read More At : www.shootingtimes.com...

The Envelope Please! My Best Rifle Sight Award Goes To ...


The Envelope Please! My Best Rifle Sight ... All you need to do is have ... instead of focusing on both front and rear sights, being sure all is perfect, you ...
Read More At : www.gunsamerica.com...

How to Field Strip, Disassemble, Reassemble, Clean & Maintain ...


... your M4 rifle may need ... Removing any sights that have been zeroed will require you to re- zero them, so DO NOT remove ... For the adjustable rear sights, ...
Read More At : guns.wonderhowto.com...

Suggested Questions And Answer :


Have a Surefire Executive Elite E1e. I purchased it new in 2007 prior to deploying to Afghanistan. After a period of 7 months, the bulb burned out. I ordered a new bulb and replaced the old bulb. It lasted a couple of days and then burned out. I replaced it again with same results. Replaced the battery each time so there was always a new battery in the unit.


If you can access the "guts" of the device. Try and see if there is an electrical malfunction such as frayed wire or moisture on the circuits. It sounds like an electrical short is causing the bulb to work harder that it needs to causing its life to be drastically shortened. If its an investment, I would go ahead and set up service for the device (or if you have the capabilities and know-how to repair it yourself it might be easier). Remember though any attempt to repair an item yourself might void the warranty. I did a little research and found that all products from the manufacturer are under lifetime warranty as long as they are owned by the original owner. Go ahead and send it in for an easy hastel free repair. I am not sure if you are in the us again but I have here two different numbers to set up service Toll Free: Outside US: 800-828-8809 714-545-9444
Read More At : E1E "Executive Elite" Flashlight...

Switch replacement instructions


You have to push the light down from the long rod you have there while compressing the two grids with a needle nose plier. The switch should be able to slide right out that is if it's a black switch. However...if you have the older version of the switch module that either has a clear/beige switch or clear beige/cream switch you need to bang that ****** out. Try not to hurt yourself because this can get a little tougher and may take a couple of practice to actually get that switch out. If all else fails send it back to Streamlight repair department. It's covered under lifetime warranty you know ;) www.streamlight.com follow the contact section and the addy's there. goodluck
Read More At : Streamlight 75000...

Where do you buy the bulb for the spot light how do you remove iittit


I bought those kind of on a reliable seller, I personally think they are pretty good so far. hope that will be helpful. seller link here
Read More At : 2M Pwr Rch Spotlight...

How do I remove the battery?


This is not intended to be a user replaceable battery, although I have found a replacement battery on-line.so that means that SOME people have replaced them. the cost is $9 +s&h. I don't think most camping outfitters would be able to help you with it, But it would be worth a try. My suggestion would be (if you have one in your area) take it to a Batteries Plus store. They are quite good at replacing batteries that are NOT meant for user replacement. Best of luck to you.
Read More At : Coleman...

Dont know how to go about replacing the headlight bulba


We will need more information - car model, year. Generally, you get to the back of the headlight assembly, and turn the connection 90 degrees to remove the bulb from the headlight assembly. Once the bulb is removed from the headlight assembly, you pull out the old bulb, install the new bulb, and reverse the process.For some vehicles, you have to remove the headlight assembly, on others, you have free access to the back of the headlight assembly.
Read More At : HighWatt Xenon Bulb Bright White 100W...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.backpackingtips.net || Terms of Use || Contact || Privacy Policy
Load time: 0.0232 seconds